Wodtke Momo

• Power 8 kW (70% - water / 30% - air)
• ASW Air Purification System
• High quality construction with double walls of steel and cast iron
• Ability to draw combustion air from inside and outside
• Large heat-insulated heating exchanger (volume 21 l)
• Thermal protection, immersion sleeves, ventilator, filling and drain taps integrated into the fireplace design
• Built-in air intake pipe with a diameter of 100 mm;
• Vermiculite and fireclay lining
• Vertical chimney D 150mm
• Cast iron fuel grille
• Wodtke thermal control with automatic combustion air supply

Fireplaces of the water + series contain the integrated water heat exchanger which allows to give the heat received at burning of firewood, in the central system of heat supply through the buffer capacity. Thus, fireplaces with a water circuit simultaneously heat the room in which they are installed and supply heat to the storage tank.The accumulated heat can be used at any time for hot water preparation or heating system operation. As only a part of nominal productivity of fireplaces with a water contour is taken away directly indoors, they are ideally suited for use in low-energy or passive houses. Fireplaces with a water circuit from wodtke have a very high efficiency of up to 85% and can be optimally combined with a solar installation, photovoltaic system or heat pump. From an energy point of view, these such efficient combinations of different energy sources can help minimize heating costs. Thermal protection against overheating, immersion sleeves, vent, filling and drain valve are already built into the wodtke fireplaces and guarantee optimal and very safe operation of the system.

wodtke Air Control - automatic thermoregulation of air for combustion

The wodtke Air Control system regulates the air supply to the combustion chamber to ensure an optimal combustion process. No need to use dampers or throttles. This greatly simplifies the use of the fireplace and prevents it from working incorrectly.

Thermal control Air Control consists of an air valve that connects to the temperature sensor through a capillary tube that provides hydraulic closing or opening of the valve. Thanks to Air Control, combustion air is supplied to the combustion chamber in the right place in the right amount. During the lighting of the fireplace, when the device is still cold, the fire requires a lot of primary air, which must be brought into the combustion zone through the lower grille. As the temperature increases, the oil expands in the temperature sensor and gradually closes the air damper, blocking the air duct of the primary air supply. After that, the air is supplied to the combustion zone in two ways: as secondary air in the middle zone of the combustion chamber and as an «air curtain» for blowingviewing glass. This AWS technology allows you to effectively prevent contamination of the glass in the fireplace.

In case of using ambient air for combustion of the fireplace and operation in the house with recuperation, it is necessary to provide use of the differential pressure regulator wodtke DS01 which will guarantee safe operation of system in emergency situations (for example, return draft). DS 01L Wodtke controls the pressure difference in the combustion chamber or chimney during the operation of the fireplace in relation to the pressure in the room where the fireplace is installed. If the pressure difference drops below the minimum set value, the ventilation system is switched off. Monitoring of pressure drop occurs in case of increase in temperature of flue gases of a fireplace (the temperature sensor is included).